Need help?Do you have a question about the Eachine TYRO109 and is the answer not in the manual?
General| Type | FPV Racing Drone |
|---|---|
| Frame bottom plate thickness | 2mm |
| Frame top plate thickness | 2mm |
| Flight Controller | F4 |
| ESC | 20A |
| VTX | 5.8G 40CH 25/200/600mW Switchable |
| Battery | 3S |
Details frame wheelbase, arm thickness, plate thickness, and material composition.
Lists KV rating, current, weight, thrust, and physical dimensions.
Details current ratings, chip, firmware, MOSFETs, and product features.
Explains pinout for power, signals, and BEC output.
Details STM32 F405 chip, gyroscopes, OSD, and BetaFlight support.
Maps pins for UART, receiver, LEDs, buzzer, and other functions.
Lists sensor, resolution, TV system, lens, and environmental specs.
Details output power, transmission distance, voltage, and size.
Explains how to change frequency band and channel using buttons.
Crucial advice on antenna installation and voltage for VTX protection.
Lists gain, power, connector, frequency, impedance, and polarization.
Details material, mounting hole, thickness, colors, and CW/CCW count.
Lists various screw sizes (M3, M2) and their counts for assembly.
Identifies isolation columns and rubber shock absorbers used in assembly.
Provides detailed illustrations of drone component layout for assembly.
Steps for connecting to Betaflight Configurator and setting up UART ports.
Guide to setting ESC protocol to DShot600 and receiver to SBUS.
Instructions for configuring arming and angle modes using AUX channels.
Procedure for testing positive and negative motor rotation.
Instructions for uploading custom fonts to the OSD.
Steps to calibrate the accelerometer for stable flight.
To Next Page
