Eachine TYRO99 - Esc; Product Characteristics; Interface Definition Chart

3.0 ESC
Continuous current: 30A
Peak Current: 40A(10S)
Input voltage: 2-5S
BEC: 5V 2A BEC
Main control chip: 48Mhz EFM8BB2
Firmware: BLHeli_S supports Dshot600
MOS: 5*6
Product characteristics:
The high performance EFM8BB21F16G microprocessor is used
to run up to 48MHz.The high quality 5 * 6 package MOSFET is
more reliable than the 3 * 3 package MOSFET.6 layers of high
TG 3OZ copper thick PCB sheet, greatly reduce heating and
efficiency.Using the BLHeli_S open source program, you can
upgrade the firmware or change the tuning parameters through
the throttle signal line to support the BLHeli_S completeThe
function of the Department;It can support DShot150/300/600
digital throttle mode and common PWM, OneShot125, OneShot42.
MultShot throttle mode;The built-in 5V@2A BEC can provide power
for flight control, camera, picture transmission, LED lamp and other
devices.
BAT: power positive electrode;
GND: power negative electrode;
5V:5V regulated power supply
output interface,maximum current 2A;
S1-4: throttle signal input interface,
S1 corresponds to M1.S2 corresponds
to M2, S3 corresponds to M3, S4
corresponds to M4.Number electric
adjustment;
POWER INPUT: power line pads, "GND"
corresponding power supply.The line
negative pole, "BAT" corresponds to the
positive pole of the power supply line.
Interface definition chart:
TYRO 9 9
QUICK START GUIDE
-4-