Eagle Equipment TB9000

Questions and Answers

L
Laura Hall DDSAug 12, 2025
What to do if my Eagle Equipment TB9000 engine is running but there is no power output?
- S
  Steven HunterAug 12, 2025
  If your Eagle Equipment Portable Generator's engine runs but provides no power, check these possible causes: 1. The circuit breaker might be open. Reset it. 2. There may be a poor connection or a defective cord set. Check and repair if needed. 3. The connected device could be faulty. Connect a device that is in good condition. 4. There might be a fault in the generator. In this case, contact a service center.
H
hheathAug 18, 2025
Why does my Eagle Equipment TB9000 Portable Generator engine shut down during operation?
- T
  Thomas AlvarezAug 18, 2025
  If your Eagle Equipment Portable Generator shuts down during operation, it could be due to these reasons: * The generator is out of fuel. Refill the fuel tank. * There is a fault in the engine. In this case, contact a service center.
J
Jeffrey HuntAug 25, 2025
What to do if Eagle Equipment TB9000 Portable Generator runs good until loads are connected, then bogs down?
- T
  tcolemanAug 25, 2025
  If your Eagle Equipment Portable Generator runs well until you connect loads, then bogs down, consider these potential issues: * A short circuit exists in a connected load. Disconnect the shorted load. * The generator is overloaded. See ‘Connecting Electrical Loads’ section of manual. * The engine speed is too slow. * There is a short in the generator circuit. In the last two cases, contact a service center.
N
Nicholas FlowersAug 30, 2025
How to troubleshoot lack of power in my Eagle Equipment TB9000?
- S
  suttonjacquelineAug 30, 2025
  If your Eagle Equipment Portable Generator lacks power, consider the following: * The load may be too high. See ‘Connecting Electrical Loads’ section of manual. * The air filter may be dirty. Replace the air filter. * The engine may need servicing. In this case, contact a service center.
M
mtaylorNov 5, 2025
Why won't my Eagle Equipment TB9000 Portable Generator start or why does it run rough?
- H
  Heather SharpNov 5, 2025
  If your Eagle Equipment Portable Generator won't start or runs roughly, there are several potential causes: * The On/Off switch may be in the ‘OFF’ position. If so, turn it to ‘ON’. * The battery might be dead. Try charging or replacing it. * The air cleaner could be dirty. Clean the air filter. * The generator might be out of fuel. Refill the fuel tank. * The fuel may be stale. Drain the tank and refill it with fresh fuel. * You might not be using enough speed or force for a recoil start. Review and follow the instructions. * There could be water in the fuel. Drain and refill the tank. * The speed control may not be set to 'RUN'. Move it to the 'RUN' position. * The oil level might be low. Add oil to the proper level. * The oil nozzle could be dirty. Clean the oil noz...

Summary

Description and Grounding

Product Description

Details the Model TB9000 as a gas engine powered AC generator.

Grounding the Generator

Essential safety procedure for connecting the generator frame to an earth ground.

Safety Precautions

General Safety Warnings

Critical warnings covering carbon monoxide, electrical shock, and environmental hazards.

Operational Safety Guidelines

Rules for safe operation, including ventilation, load connection, and prohibited environments.

Operation and Maintenance

Starting and Stopping the Engine

Step-by-step instructions for starting and safely shutting down the generator.

Connecting Electrical Loads

Guidance on properly connecting devices to the generator's output.

Generator Maintenance Schedule

Recommended maintenance tasks and their frequency for the generator.

Troubleshooting Guide

Common Operational Problems and Solutions

Addresses common issues like no power, bogging down, rough running, and shutdowns.

Storage Procedures

Preparing for Extended Storage

Guidelines for storing the generator to prevent hard starting and ensure longevity.

Limited Warranty Information

Warranty Coverage Details

Details the warranty period for the engine and equipment parts.

Product Specifications

Technical Specifications Summary

Lists output, receptacles, engine details, dimensions, weight, and warranty.