The motor is the drive system of the e-bike. Take good care of it will keep the e-bike
performance.
1.Daily riding: using PAS mode especially when climbing hills can reduce motor wear and
tear.
2.Maintenance: lubricate the motor when the range is at 100miles, 500miles, 1000miles,
and whenever necessary. Or it will cause motor noise. To avoid any damages caused by
improper operation, it’s recommended to do the motor maintenance in a professional
bike shop.
-6-
Motor
The display is the control board of the e-bike. The electronic system will only work after
the display is switched on. It can show the data of riding and indicate e-bike fault. Also,
you could modify the settings to make the e-bike more pleasant to ride. Please read the
display manual carefully and learn about the basic operations before your first ride.
Display
eAhora X7 comes with an integrated headlight and an taillight. It’s strongly recommend-
ed to use the lights when riding at night or in low visibility situations. Switch it on or off by
pressing th light button on the display dashboard after turning on the display.
Headlight
The eAhora X7 comes with a 8-speed Shimano derailleur system(including freewheel, rear
derailleur, gear, and shifter). This allows the rider to maintain a comfortable level of effort
and pedaling speed throughout different terrains. For instance, while pedaling in the
lo
west gear, it will be easier to pedal up hills. In the highest gear, the rider will be able to
reach higher speeds on flat or downhill terrain. 1st gear is the lowest gear while 8th gear
is the highest gear. Do NOT shift the gears if you’re not riding the bike, that may lead the
chain to be broken.
Derailleur
To Next Page
Loading...
