User manual E&P HYDRAULICS
2. Installation
2.1 Before
The procedure described below has already occurred with your installer/dealer. So you do
NOT need to perform this procedure itself.
E&P Hydraulics has chosen to add this additional chapter in this user’s guide just in case of
failure and or after service/repair.
Consider teaching/programming (pairing) of the remote control as a condition making it
possible levelling automatically or manually. When this operation for some reason has not or
incompletely been carried out it is not possible to level the caravan.
Antenna
Ensure that a antenna is connected to the main unit (operating system). If this is not the case,
the remote control can not communicate with the hydraulic levelsystem.
Basically, the antenna is present when you purchased the E&P Hydraulics levelsystem
including the remote control.
Do you have purchased the remote control at a later stage then you must be aware that this
antenna connection may be absent from the main unit. (this depends on the acquisition
period of the level system)
After 2013, all main units have this antenna connection. In this case, the installer/dealer
should mount the antenna (delivered with the remote control) to the main unit.
Extra Note: See also chapter 4 user advices - par. 4.1 Antenna
Before you start the installation procedure of the remote control you must be sure the
E&P Hydraulic level system is professionally installed and is functioning correctly.
Attention !
Be aware you are dealing with equipment that must be able to withstand huge forces
6.
To Next Page
Loading...