HINTS ON CORRECT USAGE
Use proper gauge wires for connections to get
proper readings.
Ensure all terminals are tightly screwed.
Voltage should not exceed specified limits. It will
damage the unit beyond repairs.
CAUTION
Ensure MCB protection is available between input
bus bars and unit
Since it is a high voltage device, only licensed
people should handle it. Proper care should be taken
like switching off the main incoming line before
working on the meter.
EAPL is not responsible for any consequential
damages arising out of use of our products, though
the technology is cautiously chosen and
implemented like any other well designed good
electric meter
Blinking of unit indicates over voltage.
Switch off the unit for 1minute to reset the
resetable fuse & switch on.
Applicable for Aux supply 85 to
270V AC/DC only.
DISPOSITION
Once the product life is over, you may send back the unit
to EAPL for disposition.
TROUBLE ANALYSIS
1) Phase fail display
Check whether all the 3 phase voltages are
given properly.
2) Faults like (UVOL,OVOL)
displayed
Go to program mode ( short 5&6) settings and
set the value as per the requirement.
3) Relay is not tripped
Go to the program mode and check the
“rly”option
Check whether Auto reset (6&7 terminals) are
short.
For manual mode press manual /esc button.
(After recovery from the fault or program mode)
Electronic Automation Pvt. Ltd
#20, KHB Industrial area
Yelahanka
Banglore -106
Ph
: +91-80-28567561/2 ,/42802345
Customer care:Ph:+91-80-42802323
Email : info@eaplindia.com
www.eaplindia.com
DOC NO: OD RE YN 21005 0 Dtd: 16/03/2015
Page 2 of 2
To Next Page
Loading...
