To Next PageTo Next PageHow to start EarthQuake 3365?
If the EarthQuake Tiller engine will not start: * Add gas to the gas tank. * Connect the spark plug wire to the spark plug. * Position the throttle at choke for a cold start. * For model 3365H, ensure the On/Off switch is in the On position.
How to fix EarthQuake 3365 Tiller that is hard to start?
If your EarthQuake Tiller engine is hard to start: * Drain old fuel and replace it with fresh fuel. It's also a good idea to use a gas stabilizer at the end of the season. * Ensure the spark plug wire is securely attached to the spark plug. * Make sure the drive safety control lever is released to neutral to start the engine.
How to prevent excessive heat build up in EarthQuake Tiller during tilling?
If you notice excessive heat build-up in the transmission/tine area of your EarthQuake Tiller during tilling: * Remove any vegetation. * Check the transmission fluid and fill if needed.
How to fix EarthQuake 3365 belts squealing in neutral?
To address belts squealing in neutral on your EarthQuake Tiller, follow these steps to adjust the forward belt guide: * Turn the engine off and allow the muffler to cool. * Disconnect the spark plug wire and secure it away from the spark plug. * Pull down on the drive safety control lever. * Manually bend the forward belt guide, ensuring there is 1/16 inch or less clearance between the belt guide and the belt. * Replace the spark plug wire.
What to do if EarthQuake 3365 Tiller is difficult to control when tilling?
If the EarthQuake Tiller is difficult to control when tilling (machine jumps or lurches forward): * Lower the engine speed in hard ground. * Raise the tines for shallower tilling by lowering the depth regulator lever.
What to do if EarthQuake 3365 engine runs rough, floods during operation?
If your EarthQuake Tiller engine runs rough or floods during operation, clean or replace the air cleaner.
General| Brand | EarthQuake |
|---|---|
| Model | 3365 Series |
| Category | Tiller |
| Language | English |
Outlines the owner's duty for accurate assembly and safe use of the rototiller.
Covers special messages, important precautions, safety signal definitions, Prop 65, and intended use.
A comprehensive checklist to perform before starting the engine to ensure safety and readiness.
Decals related to rotating tine danger and basic operation instructions.
Covers warnings for serious injury/death, belt cover, pinch points, and noise levels.
Step-by-step instructions for unpacking the tiller and assembling its components.
Crucial step to add engine oil before starting the tiller, as it ships without oil.
Explains the function of the lever for engaging and disengaging tines.
Lists common problems, their causes, and remedies for the rototiller.
Outlines the 1-year limited warranty, coverage, and exclusions for the rototiller.
