OPERATION MANUAL
©2018 EarthQuaker Devices LLC
<<< Power Requirements >>>
<<< Tech Specs >>>
• Current Draw: 18mA
• This device can be powered by a 9v battery or a standard 9-volt DC power supply with a 2.1mm
negative center barrel. We always recommend pedal-specic, transformer-isolated wall-wart
power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is
ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specic
power supplies do not lter dirty power as well and let through unwanted noise. DO NOT RUN
AT HIGHER VOLTAGES!
• Input Impedance: 50K Ohm • Output Impedance: <10K Ohm
<<< Warranty >>>
This device has a limited lifetime warranty. If it breaks, we will x it. Should you encounter any
issues, please email info@earthquakerdevices.com.
www.earthquakerdevices.com
<<< Switching >>>
This device is true bypass and uses electronic relay-based switching. Audio will not pass
without power.
To Next Page
Need help?
General