39
V. 2
Notes: after connection, if there is any
leakage with hose, then repeat the steps
to connect inlet pipe. The most common
type of tap shall be used to supply water.
If tap is square or too big, then standard
tap shall be changed.
PLACE OUTLET HOSE
There are two ways to place the end of outlet
hose:
1.Put it beside the water trough.
2.Connect it to the branch drain pipe of the
trough.
ELECTRICAL CONNECTION
• As the maximum current through the unit is 10A when you are using its
heating function, please make sure the power supply system (current,
power voltage and wire) at your home can meet the normal loading
requirements of the electrical appliances.
• Please connect the power to a socket which is correctly installed and
properly earthed.
• Make sure the power voltage at your place is same to that in the machine's
rating label.
• Power plug must match the socket and cabinet must be properly and
effectively earthed.
• Do not use multi-purpose plug or socket as extension cord.
To Next Page
Loading...
