What to do if my Eastey Industrial Equipment machine is not operating?
If your Eastey Industrial Equipment machine is not operating, verify that the system power meets the specification requirements. Also, clear the machine and reset the Emergency Stop.
Why is the tape on my Eastey Industrial Equipment uneven or torn?
Uneven or torn tape on your Eastey Industrial Equipment can occur for several reasons. The blade may be dull, so replace it. The tape tension may be incorrect, so increase it. You may also need to clean and adjust the blade. If the knife arm spring is worn, replace it. Finally, adjust the cartridge height.
Why is the tape leg on the front of my Eastey Industrial Equipment uneven?
If you're experiencing an uneven tape leg on the front of your Eastey Industrial Equipment, it could be due to low tape tension. Try tightening the one-way clutch roller and/or the tape core. Another solution is to adjust the one-way clutch roller in the slot so it is slightly beyond the front wipe roller. Also, consider adjusting the tape leg length.
How to fix an Eastey Industrial Equipment taper that will not start?
If your Eastey Industrial Equipment taper will not start, check the power input and ensure it is properly connected. Also, release the Emergency Stop button and press the Start button to release any overload. Finally, replace the fuse, accessing it by removing the plug from the underside of the control box.
What to do if the tape is curling and bunching up on my Eastey EX Tape Head Only Industrial Equipment?
If the tape is curling and bunching up on your Eastey EX Tape Head Only Industrial Equipment, adjust the tape cartridge height to approximately .06 inches from the box. Also, check the tape tension set by the spring tension at the tape core.
Why are there uneven or poor tape cuts on my Eastey Industrial Equipment?
Uneven or poor tape cuts on your Eastey Industrial Equipment can be resolved by adjusting the knife arm spring tension. Also, adjust the wipe roller spring tension. If the problem persists, replace the cutting knives.
What to do if a carton is stuck in my Eastey Industrial Equipment?
If a carton is stuck in your Eastey Industrial Equipment, check the drive belt width adjustment and the proper height adjustment.
Why is the tape folding on my Eastey Industrial Equipment?
If the tape is folding on your Eastey Industrial Equipment, check that all rollers turn freely and check the wipe down brush.
Essential safety instructions for operating and servicing the equipment.
Step-by-step guide for loading tape rolls into the machine.
How to check and adjust tape tension for proper sealing.
Instructions on how to thread the tape through the tape head mechanism.
Details the function and reset procedure for the emergency stop button.
How to adjust the machine to fit different box sizes.
Adjusts the width of the side belts for proper box guidance.
Sets the vertical position of the upper tape head for optimal sealing.
Adjusts the top squeezer for correct box centering and width.
Solutions for machine start-up failures and general operation problems.
Addresses issues related to boxes getting stuck or misfed.
General| Model | SB-2EX |
|---|---|
| Category | Industrial Equipment |
| Maximum Product Height | 24 inches |
| Material | Steel |
| Color | Gray |
| Usage | Packaging |
| Electrical | 110V |
To Next Page