What to do if auto-dimming is not working on my Eastwood Motorcycle Accessories helmet?
If the auto-dimming feature on your Eastwood Motorcycle Accessories helmet isn't working, the sensors or solar cells might be blocked by dirt. Try cleaning the lens assembly. Also, low batteries could be the cause; expose the solar cells to a bright light source to recharge them.
Why is the 'Low-Bat' indicator glowing on my Eastwood Motorcycle Accessories helmet?
If the “Low-Bat” indicator is glowing on your Eastwood Motorcycle Accessories helmet, it means the batteries need recharging or replacement. Replace them with two CR2450 batteries or recharge them.
Why is the darkening response slow on my Eastwood Motorcycle Accessories helmet?
If your Eastwood Motorcycle Accessories helmet is slow to darken, it might be too cold; do not use it below 23°F (-5°C). Also, the sensitivity setting may need adjustment.
What to do if my Eastwood Motorcycle Accessories helmet slips during use?
If your Eastwood Motorcycle Accessories helmet slips during use, it means the fit isn't adjusted properly. You should adjust the helmet fit.
How to improve vision through the lens of my Eastwood Motorcycle Accessories helmet?
If you have poor vision through the lens of your Eastwood Motorcycle Accessories helmet, dirt or excessive pitting may be blocking your view. Clean the lens assembly.
Thoroughly read and understand this manual before using the welding helmet for safe operation.
Warning about potential electric shock during welding operations and necessary precautions.
Warning regarding arc ray shading levels and potential for permanent eye injury if inadequate.
Instructions for adjusting the sensitivity and delay controls of the auto-darkening feature.
Guidance on setting the shade level based on welding process and current using the shade guide table.
Procedures for adjusting the headband, width/height, and flip-up retention for a secure fit.
Instructions for replacing batteries, cleaning the lens, and checking for damage.
Guidance for identifying and resolving common issues like auto-dimming failure or poor vision.
Information on available replacement parts such as outer and inner lenses for the welding helmet.
General| Brand | Eastwood |
|---|---|
| Model | L6700 |
| Category | Motorcycle Accessories |
| Language | English |
To Next Page