29
-
Note:
After each force setting (values F1-F6) that deviates from the factory setting (value F4), compliance with the force limit values required by
law or in the relevant standards must be checked, approved, measured and documented by a competent person in order to rule out the
aforementioned risks to life and limb and damage to property.
1.
2.
3.
Remark:
Photocell
1.
2.
3.
If you are not using a photocell, make sure that the setting is set to "H0". Otherwise the operator
will not function!
Automatic close
Remark:(Automatic close not possible without photo-
cell).
1.
2.
3.
The factory setting is "b0". "b0" means that automatic closing is deactivated. The function starts
at door position "Open". Function only possible with active photocell.
Programming the remote controls
Remark
instructions below.
1.
2.
3.
Deleting stored remote controls
1.
2.
3.
To Next Page
Loading...
Need help?
General