Open the memory card cover according to “ Micro SD ” on the
sticker , Make sure the metal contacts facing down . Insert the
narrow end of the card i nto the card slot until the whole card
fitscompletely. Close the card cover to complete the installation.
(Please refer to Figure 3).
5.Keep the battery notch at the top, put the metal contacts to the
top left corner, get it into the battery compartment, and press to
load the battery.(Please refer to Figure 4).
Warning:
Power ON and OFF
1.Power ON
Press and hold the power button for 3 seconds to power on
your phone.
2. Power OFF
Press and hold the power button for 3 seconds to power off
your phone.
（Note: When your phone is low battery, the device will shut down
automatically.）
Do not insert or remove the memory card quickly or frequently
to avoid damaging the memory card.
Warning:
When you are in a place where you are prohibited from using
mobile phone or using a phone may cause interference and
danger, please do not power on your mobile phone and ensure the
phone does not turn on the timer switch and other functions.
Get to know your phone
9
To Next Page
Loading...
