easymaxx MS-101 User Manual (English)

Questions and Answers:

L
Laura CharlesAug 3, 2025
Why does the thread keep breaking on my easymaxx MS-101?
- C
  Christopher MartinezAug 3, 2025
  If the thread breaks on your easymaxx Sewing Machine, consider these possible causes and solutions: * Ensure the machine is threaded properly. * Remove any tangles in the thread. * Adjust the thread tension if it is too high. * Make sure the thread reel or coil is placed correctly. * Replace the needle if it is bent or dull. * Verify that the combination of needle size, thread size, and fabric is correct.
P
Patrick PetersenAug 8, 2025
What to do if my easymaxx MS-101 Sewing Machine does not start?
- B
  Brian FreemanAug 8, 2025
  If your easymaxx Sewing Machine doesn't start, there are several potential causes: * If using batteries, ensure they are inserted correctly and are not empty. Replace them if necessary. * If using mains power, verify the mains adapter is securely plugged into both the socket and the sewing machine. Also, check the fuse of the mains connection. * Try a different socket to rule out a defective socket.
S
Samuel LambAug 13, 2025
Why does the needle break on my easymaxx MS-101 Sewing Machine?
- D
  djonesAug 13, 2025
  If the needle breaks while using your easymaxx Sewing Machine, here’s what could be happening: * The needle might not have been inserted correctly, so ensure it is properly inserted. * You might be using a bad needle, so try replacing it. * The combination of needle size, thread size, and fabric might not be correct, so ensure you are using the appropriate combination. * You might be pulling the fabric too much. Let the carrier push the fabric further, instead of pulling on it.
C
cunninghamantonioAug 18, 2025
What to do if easymaxx MS-101 Sewing Machine stitches are omitted?
- C
  Christopher PaulAug 18, 2025
  If your easymaxx Sewing Machine is skipping stitches, here are some things to check: * Make sure the needle is inserted correctly. * Try replacing the needle, as you might be using a bad one. * Ensure you are using the correct combination of needle size, thread size, and fabric. * Clean the throat plate if there are fibers or lint on it. * Adjust the thread guide to the correct position.