EasyPro ECF10 - Pressure Filter Installation; Safety and Electrical Connections

Pressure Filter Installation
Please read all instructions carefully and keep for future reference
Safety and Electrical Connections
• Always disconnect the electrical supply before starting to handle, maintain, repair or install
any pond equipment.
• Thisproductisnotsubmersibleanditmustbesitedwhereitcannotfallintothewaterorbecome
waterlogged.However,thedesignisweatherresistant,andEasyProlterscansafelybeinstalled
outdoors.
• DirectexposuretoUltra-Violetlightcandamageeyesandskin.Donotattempttoviewthelamp
whenlit,exceptbrieythroughtheviewingwindow.
• ConnectthisproductonlytoareceptacleprotectedbyaGroundFaultCircuitInterrupter.(GFCI)
• Protectfromthefrost.Ifthepondisnotgoingtorunallwinter,drainthelterandremovefromthe
groundandstoreinawarmdryplace.
• Allelectricalworkmustbeperformedbyaqualiedtechnician.AlwaysfollowtheNationalElectrical
Code(NEC)ortheCanadianElectricalCodeaswellasalllocal,stateandprovincialcodes.Code
questionsshouldbedirectedtoyourlocalelectricalinspector.Failuretofollowelectricalcodesand
OSHAsafetystandardsmayresultinpersonalinjuryorequipmentdamage.Failuretofollowmanu-
facturer’sinstallationinstructionsmayresultinelectricalshock,rehazard,personalinjuryordeath,
damagedequipment,provideunsatisfactoryperformanceandmayvoidmanufacturer’swarranty.
Installation of the Pressure Filter
1. TheECF10U,ECF25UandtheECF40UcomewiththeUVlightalreadyinstalled.
2. Positionpumpatthefurthestpointfromthewaterfall.Runthetubingoutofthepondandburyor
concealthetubing.
3. ItisrecommendedthatthepumpbehousedinanEasyProskimmerorinanEasyProsubmersible
pumpprotector.
4. Positionthepressurelteranywherearoundthepond.Sincethedischargeisunderpressure,the
ltercanbelocateddownhillfromthewaterfall.
5. Digaholebigenoughfortheltertositin.Digtheholedeepenoughsotheretainingringisleft
exposedoutoftheground.
6. Ifinstallingaunitwithclips,makesuretheclipsareleftexposedoutoftheground.
7. Recessthelterintothepreviouslydughole.
8. Connectthetubingfromthepumptotheblackbarbedtting,whichattachestotheintake,whichis
markedwithanarrowpointingin.
9. Connectthetubingfromthewaterfalltotheclearbarbedttingthatisthenattachedtothedis-
charge,whichismarkedwithanarrowpointingout.
10.Runthetubingtothewaterfallandburythetubingforthebestlook.
11.IfthepressurelterunitisequippedwithaUVlightmakesureitisproperlypluggedintoaGFCI
protectedoutlet.
12.Backllaroundthepressurelter.Concealyourpressurelterandtubingwithyourchoiceofland
-
scaping.
2