Easyrig STABIL - User Manual

Adjusting the tension
Adjust the tension on your Vario 5
to match the tension on the Easyrig
STABIL. If you have a Cinema 3 skip this
step.
Before adjusting the tension on your
Vario 5, make sure to lock the arm or
keep it at the lowest position with your
hand to avoid interference from the
Easyrig STABIL.
For further details please read the Vario
5 user manual.
Adjusting the tension
Increase the tension of the spring by turning
the knob clockwise. The knob will make a
clicking sound to indicate your new setting.
Decrease the tension by turning the knob
counter-clockwise. The Easyrig STABIL can
take weights between 5-25 kg (11-55 lbs).
The Easyrig STABIL is adjusted correctly if
the arm is resting between the lowest and
highest position.
Adjusting the slider
Place the camera hook in front of the
upper arm (1). Adjust the slider (2) to
preferred location and lock it tight. When
the slider is in position, gently put back
the camera hook.
The Easyrig STABIL has ball bearings
in the back of the arm, enabling smooth
lateral movement from left to right. This
smooth lateral movement together with
the spring (up and down) will make your
shots steadier.
Turn page
1
2
3
Easyrig STABIL User Manual - rev.02 - 2019-04-30
Easyrig STABIL

Summary

Easyrig STABIL Adjustments

Adjusting the Tension

Adjust the tension on your Vario 5 to match the Easyrig STABIL. Skip if using Cinema 3. Lock Vario 5 arm at lowest position to avoid interference.

STABIL Tension Adjustment

Turn knob clockwise to increase spring tension (clicks indicate setting). Turn counter-clockwise to decrease. Supports 5-25 kg (11-55 lbs).

Adjusting the Slider

Place camera hook in front of upper arm, slide to preferred location, and lock. Ball bearings enable smooth lateral movement.

Easyrig STABIL Height Adjustment

Vario 5 Power Pack Height

Open Vario 5 cover, turn 4 corner nuts counter-clockwise to slide power pack up or down for height adjustment.

Upper Arm Height Adjustment

Release two screws on upper block (under rubber bellow) to raise upper arm. Ensure Vario 5 power pack is at its lowest before this.

Locking the Easyrig STABIL Arm

Arm Locking Mechanism

Line up holes and insert the locking pin located in the base of the arm to lock it at 90 degrees. Screw pin until flush with arm side.

Easyrig STABIL Specifications

General

Type	Camera Stabilizer
Adjustable Height	Yes
Color	Black
Material	Aluminum and steel
Height	Adjustable
Max Load Capacity	Varies by model (STABIL Light: 5-12 kg / 11-26 lbs, STABIL: 12-25 kg / 26-55 lbs)
Weight Capacity	Varies by model (STABIL Light: 5-12 kg / 11-26 lbs, STABIL: 12-25 kg / 26-55 lbs)