Need help?Do you have a question about the Eaton 5433 and is the answer not in the manual?
Details drive shaft assemblies for various models, including part numbers and specifications.
Procedures for removing shaft seals for lip seal and face seal motor configurations.
Initial disassembly steps for valve blocks and integral shuttle end covers.
Disassembly steps for motors with integral shuttle and low pressure relief valve.
Steps for disassembling the rotating group and its internal parts.
Procedures for cleaning, lubricating, and assembling the rotating group.
Instructions for measuring and verifying the fixed clearance of the motor.
Procedures for checking and adjusting the output shaft end play.
Instructions for installing shaft seals for various motor configurations.
Details on bullet/driver selection and dimensions for shaft seal installation.
To Next Page
General
