2
2000 Series Disc Valve Motors
Exclusion
Seal
Bearing
Housing
Seal
Back-up
Washer
Shaft
Seal
Bearing and
Shaft
Assembly
Key
Shaft
Face Seal
Wear
Plate
Seal
Seal
Valve
Plate
Splined
Drive
Geroler
Valve
Drive
Pin
Spring
Valve
Housing
Tie
Bolt
Inner
Face Seal
O-ring/
Plug S/A
O-ring/
Plug S/A
O-ring/
Plug S/A
Shuttle Vave Option
Piston
Spring
Poppet
Poppet
Spring
Dash Pot
Dash Pot
Balance
Ring
Outer
Face Seal
Valve
Seal
8,0 [.312]
Grind flat spots on each side
Approx. 13,0 [.50]
200,0 [8.00]
Alignment studs (2)
25,0 [1.00]
3/8-24 UNF thread
9,5 [.375] Dia. Steel Rod
Tools required for disassembly and reassembly.
Torque wrench 57Nm [500 lb-in] capacity
300-450 [12-16]* breaker bar
9/16 socket
Small screwdriver 150-200 x 6,5 [6-8 x 1/4] blade
3/16 Allen wrench
Press
* Unless indicated otherwise, measurements
are given in mm [inches]
** Shaft seal installation tool (600496)
** Bullet (600465) for 1 diameter shafts
The following tools are not necessary for disassembly and reassem-
bly, but are extremely helpful.
Alignment studs (2)
To Next Page
Loading...
