42
Appendix M: Alarm/status messages
DPCT IOM INSTRUCTION OPERATION MANUAL MN124018EN January 2023 www.eaton.com
Remote Auto Start The pump has started via a remote auto start signal.
Remote Auto Start Off The input to the remote auto start terminals has been removed.
Remote Manual Start The pump has started via a remote start signal.
RPT Timed Out The running period timer has finished its timing cycle.
RPT Stopped The Run Period Timer has finished timing or been cleared.
Speed SW Malfunction The engine run signal has been removed prior to the controller initiating a stop.
SST Started The sequential start timer has started timing.
SST Stopped The sequential start timer has finished timing or been cleared.
System Startup Power has been reapplied to the system and a successful system boot has been completed.
Transducer Fail The controller has detected that the transducer has failed.
Weekly Test Done The weekly test has been completed.
Weekly Test Fail A Weekly test has been initiated; however, the engine has failed to start.
Weekly Test Start The engine has started on a weekly test.
Weekly Test Stop The Weekly Test Cycle timer has been cleared.
To Next Page
Loading...
