Eaton FO-20E318B-MXP - Release Yoke and Cross-Shaft(s) Installation

118
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Release Yoke and Cross-Shaft(s) | Removal and Installation TRSM0940
5. Remove the upper Cross-Shaft Seal assembly.
6. If necessary, remove the 2 upper Cross-Shaft Bush-
ings.
Release Yoke and Cross-Shaft(s) Installation
1. If previously removed, install the 2 upper Cross-Shaft
Bushings.
Note: Make sure to apply grease to the bushings.
2. If previously removed, install the upper Cross-Shaft
Grease Seal.