Eaton FO-20E318B-MXP - Main Case Counter Shaft Installation

2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
159
TRSM0940 Removal and Installation | Oil Pump and Lube Tube Installation
2. Mark two adjacent teeth on the Main Drive Gear with
highly visible ink or dye, then mark two more teeth 180
degrees apart.
Note: There should be an equal number of teeth in
between both marks, counting both directions around
the gear.
Main Case Counter Shaft Installation
1. Using a J-hook, install the lower Counter Shaft into the
Transmission Main Case.
Note: Place the back of the lower Counter Shaft into
the rear Counter Shaft Bearing bore and carefully
swing the Counter Shaft into place.
2. Using a J-hook, install the upper Counter Shaft into the
Transmission Main Case.
Note: Place the back of the upper Counter Shaft into
the rear Counter Shaft Bearing bore and carefully
swing the Counter Shaft into place.