2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
85
TRSM0940 Auxiliary Section Service Procedures | MHP/MXP/VHP/VXP Auxiliary Countershaft Installation
7. Place the Auxiliary Housing over the Countershaft
Assemblies and the Auxiliary Mainshaft Assembly.
8. Ensure the rear Auxiliary Mainshaft bearing spacer is
installed on the shaft.
9. Heat the Rear Auxiliary Mainshaft Bearing cone and
install the bearing, tapered side down, on the shaft.
10. Position a new gasket on the Rear Bearing Cover, and
install the cover.
To Next Page
Loading...