2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
101
TRSM0940 Removal and Installation | Input Shaft
5. Install the Input Shaft Bearing onto the Input Shaft.
Note: The external snap ring on the Input Shaft Bearing
should face out.
6. Using a Flanged-end Bearing Driver install the Input
Shaft Bearing into the Transmission Main Case until the
snap ring groove is fully visible.
7. Install the Input Shaft snap ring.
8. Install the Front Bearing Cover and gasket. Make sure
the oil return and gasket line up with the oil return hole
in the Main Case.
9. Install the Front Bearing Cover and gasket; torque the
six cap screws to 35–45 lb-ft.
To Next Page
Loading...