164
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Oil Pump and Lube Tube Installation | Removal and Installation TRSM0940
17. Line up the marked tooth on the upper Counter Shaft
with the two marked teeth on the Main Drive Gear.
Note: Ensure the lower Counter Shaft is still in time
with the Main Drive Gear before moving the upper
Counter Shaft into place.
18. Using the rear Counter Shaft Bearing Driver,
RR1012TR-4, drive the rear bearing onto the upper
Counter Shaft and into the intermediate wall of the
Transmission Main Case until there is enough room to
install the rear Counter Shaft Bearing snap ring.
19. Install the rear upper Counter Shaft Bearing snap ring.
To Next Page
Loading...