168
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Oil Pump and Lube Tube Installation | Removal and Installation TRSM0940
33. Install the oiling system halo through the bores in the
front of the Transmission Main Case until all O-rings
are fully seated.
34. Install the Front Bearing Cover and gasket.
Important: Confirm the oil return path from the Front
Bearing Cover and the gasket return port are aligned.
35. Install the six cap screws that fasten the Front Bearing
Cover to the Transmission Main Case. Torque the cap
screws to 35–45 lb-ft.
To Next Page
Loading...