184
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Range Cylinder LAS/VAS Model | Disassembly and Assembly TRSM0940
3. Install a new O-ring on the Range Piston and Range
Yoke Bar. Lube with silicone.
4. Install the Range Piston into the cylinder and onto the
yoke bar.
5. Torque the bolt 35–45 lb-ft.
6. Install a new gasket between the Range Cylinder and
the Range Cylinder Cover.
Note: Verify that the small air passage is located at the
bottom to align properly with the cover.
7. Install the Range Cylinder Cover and 4 bolts. Torque
bolts 30–35 lb-ft.
To Next Page
Loading...