238
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Main Case Disassembly and Lubrication Tube Removal | Disassembly and Assembly TRSM0940
10. Remove the snap ring from the upper Counter Shaft
Rear Bearing.
11. Using a soft bar, drive the rear Counter Shaft Bearing
out from the intermediate wall and off of the upper
Counter Shaft.
12. Remove the front Counter Shaft Bearing bolt and
retainer using a 15/16” socket.
13. Using the K-Line soft maul with hand guard, strike the
case to the left of the front Counter Shaft Bearing to
drive it out of the bore.
To Next Page
Loading...