2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
53
TRSM0940 Auxiliary Section Service Procedures | VCS/VMS Auxiliary Section Assembly and Installation
Auxiliary Section Assembly
1. Assemble the Deep Reduction Sliding clutch over the
splines on the Auxiliary Main Shaft. Install the clutch
from the front of the shaft.
2. Prepare the Low Range Gear for timing. Mark any tooth
on the gear and repeat on the tooth directly opposite of
the first marked.
3. On the Low Range Gear Coupler, install the bushings if
removed.
4. Install the Low Range Gear (Reduction Gear) over the
Coupler.
5. With the splined washer facing up, place the washer in
ID of the Low Range Gear. Rotate the washer so that it
locks in place and aligns the drive pin holes.
To Next Page
Loading...