2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
115
TRSM0940 Removal and Installation | Low Capacity Inertia Brake (LCIB)
LCIB Removal
Note: The Transmission, Cross Shaft, Release Yoke and
ECA must be removed prior to removing the LCIB.
1. Remove the 2 mounting nuts with a breaker bar and
socket.
2. Remove the LCIB by hand by sliding off of the splined
Input Shaft.
LCIB Installation
1. Slide the LCIB onto the splined Input Shaft while cen-
tering the holes onto the retaining studs.
2. Install the 2 retaining nuts and torque nuts to 140–150
lb-ft (190–203 N•m).
Note: The LCIB can only be installed one way. The label
is toward the right side of the vehicle and facing the fly-
wheel.
To Next Page
Loading...