2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
151
TRSM0940 Removal and Installation | Rail Position Sensor
Rail Position Sensor Removal
1. Disconnect the Transmission Harness from the Rail
Position Sensor.
2. Using a 5/32” hex key wrench, remove the 2 sensor
hex key mounting screws.
Caution: Carefully allow the sensor to rotate to a
relaxed position, or the sensor can snap when the hex
key mounting screws are removed.
3. Remove the Rail Position Sensor and gasket from the
housing.
To Next Page
Loading...