2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
219
TRSM0940 Disassembly and Assembly | Main Case Main Shaft without Low Force Gearing Assembly
Main Case Main Shaft Assembly
1. Place the Main Shaft vertical and hold the noise in a
vise or a pilot hole in a piece of wood.
2. Install the first stepped washer with the stepped side
facing down so it will contact the 4th/5th sliding clutch.
3. Use a piece of 5/32” air line to push up through the key
way groove to lock the stepped and no-burn washers
in place as the Main Shaft is built.
4. Install the Overdrive Gear or Direct Drive Gear
(depending on the model of the transmission) and the
no-burn washer. Rotate the washer and push the air
line through.
5. Install the 3rd Gear and stepped washer. Rotate the
stepped washer and push the air line through.
To Next Page
Loading...