2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
225
TRSM0940 Disassembly and Assembly | Main Case Main Shaft with Low Force Gearing Disassembly
5. Remove the key from the Main Shaft keyway.
Note: When removing no-burn washers or spacers,
note their location on the Main Shaft to facilitate reas-
sembly. Keep each washer with the corresponding gear
it was mated against.
6. Remove the 1st stepped no-burn washer from the
Main Shaft.
Note: There are two types of washers used on the Main
Shaft. The stepped washers (left) fit between gears and
sliding clutches with the stepped edge facing the slid-
ing clutch. The flat no-burn washers fit between gears.
To Next Page
Loading...