2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
29
TRSM0940 Auxiliary Section Service Procedures | LAS/VAS Auxiliary Section Assembly and Installation
5. Mark any two teeth 180 degrees apart on the Range
Reduction Gear using a highly visible dye.
6. Place the inner bearing (longer rollers) tapered side up
over the Auxiliary Main Shaft.
7. Drive the bearing down to the Auxiliary Reduction Gear
using the Output Shaft Bearing Driver.
8. Slide the bearing spacer down on top of the inner bear-
ing.
To Next Page
Loading...