2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
31
TRSM0940 Auxiliary Section Service Procedures | LAS/VAS Auxiliary Section Assembly and Installation
3. Place the Auxiliary Main Shaft positioning cone around
the splines of the shaft, set the Main Shaft upright with
the Synchronizer facing down.
Note: Cone size must be 4-3/8" tall with a 4" inner
diameter. PVC pipe is recommended.
4. Move the upper and lower Counter Shafts into place on
the Range Reduction Gear lining up the timing marks
previously made.
5. Position the Range Shift Yoke on the Range Synchro-
nizer Sliding Clutch with the shaft aligned above the
lower Counter Shaft.
6. Install the double bearing race into the Auxiliary Case
with the race flange out.
7. Before installing the Main Case, remove excess RTV
sealant from the mating surfaces of the Auxiliary Case
and Main Case.
To Next Page
Loading...