44
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
VCS/VMS Auxiliary Section Removal and Disassembly | Auxiliary Section Service Procedures TRSM0940
Auxiliary Section Disassembly
1. Remove the 5 cap screws that fasten the Combination
Cylinder Cover to the Auxiliary Main case. Remove the
Range Cover.
2. Remove the 15/16” & 3/4” nuts that fasten the Range
and Reduction Pistons to the Range and Reduction
shift Yoke bars.
3. Remove the Combination Cylinder assembly.
Note: For Combination Disassembly and Assembly,
see
4. Prepare the Auxiliary Section to remove the Auxiliary
Counter Shafts. For ease of disassembly, mount the
Auxiliary Section upright in a vise.
To Next Page
Loading...