50
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
VCS/VMS Auxiliary Section Removal and Disassembly | Auxiliary Section Service Procedures TRSM0940
Auxiliary Mainshaft Assembly Disassembly
1. Remove the bearing inner spacer from the Output
Shaft
2. Using the Deep Reduction Gear front as a base, press
the Output Shaft through the bearing and gear.
Note: If reusing the bearing set, the tapered roller bear-
ings are specific to each side of the race.
3. Remove the spacer and stepped washer from the Deep
Reduction Gear
To Next Page
Loading...