2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
81
TRSM0940 Auxiliary Section Service Procedures | MHP/MXP/VHP/VXP Auxiliary Section Assembly and Installation
4. Install the Splitter Gear on the Output Shaft
Note: For Splitter Gear Disassembly and Assembly, see
the section: Splitter Gear Bearing Disassembly &
Assembly, in this manual.
5. Install the Splitter Gear retainer and 15/16” cap screw.
Torque to 190-210 lb-ft (257.61-284.72 N•m).
Note: Ensure proper torque is applied to the retainer
bolt.
To Next Page
Loading...