Eaton FS-5005A - Installation: Clutch Housing

REASSEMBLY - TRANSMISSION
Installa tion of Malnshaft (cont.)
'
3 3. rns1an 1he main shal1 1ear outer llEWtng taco 1n 1119
Olltpu l shaft bearlng bore.
1n
34. II a new od seal iS required, Install using e llanged
driver. Coat the oil seal ouLor dt.ameter with Lociite #51 O.
55
35. Coal both sides of a nevi rear beanng oover
with Loctite #510 , and posffion 1he gasket on the rear
bearing cover Install the rear bearing oover. position the
lutxlcatton on groove w!lh case hole .
N OTE: Roar bflaring cover tS marked IOI proper inslalla·
uon
36. Tigh1.en the lroo1 beating cover capsctews to 30 If! · lbs
ol totque . Using 1wo reeler gages at the capsaew toca·
oons, record the gap bB!wQeo the fron1 bearing cover and
the transmlSSiOn case. Average the two recorded moos·
urementsa11d add 0.016. This you a shim pack
1
hickn&ss 10 start the end pt.ay measurement Combine 1ho
$hims to equal ltlO 10 1 a1 shim pack rneasuremen1 from the
above p1ocedure . Remov& the ffonl beating cover and
in$1all lhe shim pack. Reptace 1he lfon1 beanng cover and
lour ca1ainmg ca,pscraws. tig ltten capscrS\.,,S 10 recom·
me.nded lo(que.