KEY-RKPZ Two-Way Radio Keypad
Installation Instructions
Introduction
The KEY-RKPZ is a radio
keypad for use with i-on
and Menvier intrusion
systems. The keypad
provides full access to
configure, set or unset
the system, and is an
essential component
of Eaton fully-wireless
intrusion systems.
Being a radio device, the KEY-RKPZ offers ease of installation
and provides greater flexibility when deciding where to locate
both the control unit and keypad.
The keypad uses a separate “base station” (KEY-RKBS), which
provides a communications bridge between the keypad and
control unit. The base station uses radio communications with
the keypad, and a standard RS485 wired connection to the
control unit. Each base station can communicate with up to two
keypads.
Features:
•
Radio keypad, giving full access to configure, set or unset the
system.
•
Easy installation.
•
Internal proximity reader.
•
Backlit display and keys.
•
Navigation keys for installer and user menus, with built-in
alert LEDs.
•
A, B, C, D setting and unsetting keys, with built-in status
LEDs. An engineer can configure the keys to set individual
wards, partitions or part-sets, or to control outputs.
To Next Page
Need help?
General
