Need help?Do you have a question about the Eaton TC 48 and is the answer not in the manual?
Identifies the manual for TC 48 / TC 96 Auto-Tune Fuzzy / PID Process / Temperature Controllers.
Details Fuzzy Logic PID, accuracy, sampling rate, and auto-tune capabilities of the controller.
Explains ordering codes, keypad functions, menu overview, and parameter descriptions.
Covers unpacking, mounting, and wiring precautions for safe and correct controller installation.
Details power wiring, sensor input, control output, and alarm wiring diagrams for setup.
Covers lockout, signal input, unit selection, and control output configurations.
Explains alarm functions, user menu, ramp, dwell timer, PV shift, filter, and tuning methods.
Demonstrates heat-only and cool-only control configurations with system diagrams.
Provides recommendations and safety advice for controller calibration by experienced personnel.
Details power, input characteristics, sensor lead resistance, and rejection ratios.
Covers output ratings, control modes, alarm functions, user interface, and DC voltage supply.
Lists operating environmental conditions, dimensions, weight, and approval standards.
Lists controller error codes and provides corrective actions for troubleshooting.
Outlines the product warranty terms, buyer's remedies, and indemnification clauses.
Identifies the manual for TC 48 / TC 96 Auto-Tune Fuzzy / PID Process / Temperature Controllers.
Details Fuzzy Logic PID, accuracy, sampling rate, and auto-tune capabilities of the controller.
Explains ordering codes, keypad functions, menu overview, and parameter descriptions.
Covers unpacking, mounting, and wiring precautions for safe and correct controller installation.
Details power wiring, sensor input, control output, and alarm wiring diagrams for setup.
Covers lockout, signal input, unit selection, and control output configurations.
Explains alarm functions, user menu, ramp, dwell timer, PV shift, filter, and tuning methods.
Demonstrates heat-only and cool-only control configurations with system diagrams.
Provides recommendations and safety advice for controller calibration by experienced personnel.
Details power, input characteristics, sensor lead resistance, and rejection ratios.
Covers output ratings, control modes, alarm functions, user interface, and DC voltage supply.
Lists operating environmental conditions, dimensions, weight, and approval standards.
Lists controller error codes and provides corrective actions for troubleshooting.
Outlines the product warranty terms, buyer's remedies, and indemnification clauses.
General| Mounting | Panel mount |
|---|---|
| Operating Temperature | 0 to 50 °C (32 to 122 °F) |
| Power Supply Frequency | 50/60 Hz |
| Input Type | Thermocouple, RTD |
| Output Type | Relay, SSR drive |
| Control Mode | PID |
| Supply Voltage | 100 to 240 VAC |
| Dimensions | 48 x 48 mm |
| Setpoint Range | Depends on sensor type |
| Relative Humidity | 35 to 85% RH (non-condensing) |
To Next Page
