Transmission appearance may differ, procedure is the same.
14
Output Shaft Assembly
How to Assemble the Output Shaft Assembly
5. With chamfer side up, position the LO range gear
rear washer on the output shaft against the LO
range gear.
6. With tapered side up, use heat or appropriate
driver and install the output shaft front rear
bearing.
7. On the output shaft, position the bearing inner
spacer. Set aside.
8. Lay the auxiliary housing front face down on a
clean, flat surface. Install the front bearing cup.
9. Install the rear bearing spacer and rear bearing
race in the bearing bore.
10. Place the rear bearing cup against the spacer.
Use a flanged-end driver to move all three (3)
parts evenly into the bore until the rear bearing
cup lip seats on the auxiliary plate.
A/08-2
A/08-1
S/35-6
S/35-7
continued
9
8
S/35-3
5
6
7
To Next Page
Loading...
