1 Main Street • Whitinsville, MA 01588 • Phone (800) 992-5013 • FAX (508) 234-8251
0004703 (C)
Installation Instructions
JFX88 BRACKET
1. Inventory
Before beginning installation, inventory kit to items listed.
Item
EAW P/N Qty
Description
1 0004702 1 Bracket/Wallmount/HDJF88WM
2 102017 2 Screw, 1/4-20 x 1 SHCS, Black
3 105061 2 Washer, Neoprene, 3/8 I.D. X 2 O.D.
4 105007 2 1/4 Washer, Flat, Black
5 105008 2 1/4 Washer, Lock, Black
Warning:
Installation should only be done by an experienced technician. Improper
installation may cause serious injury. The surface where the bracket/cabinet
is to be fastened must have enough structural integrity to support 200 pounds.
2. Mounting the Bracket
Due to various construction methods and materials used today, the hardware for securing the bracket to
the mounting surface is not supplied. It is recommended that you consult a building professional for the
proper mounting hardware before mounting the bracket.
3. Removing the Shipping Hardware
Remove the flat head screws from the
top of the cabinet and the front of the
top hat flange on the bottom of the
cabinet using a 5/32 Allen wrench.
4. Choosing which Slot to Use There are
two slots in each bracket arm. Use the
forward slot (as shown) when the
cabinet is facing perpendicular to the
bracket mounting surface.
5. Hanging the Cabinet
A. Place a neoprene gasket on the
bracket’s lower arm. Center it on
the appropriate slot.
B. Position the cabinet between the
bracket arms.
C. Align the bracket’s top slot to the
cabinet’s 1/4-20 threaded hole.
D. Holding the cabinet in position,
insert the screw with its lock washer
and flat washer through the bracket
slot and into the cabinet’s top
threaded hole and hand tighten.
E. Repeat step D through the bottom
bracket hole.
F. Position cabinet and tighten both
screws with a 3/16 Allen wrench.
Need help?
General
