EAW KF850z Instructions And Installation Guide

Instructions/Installation KF850z
Bi-Amp Crossover Retro Kit
DESCRIPTION:
This KF850z Bi-Amp Crossover Retro Kit is used for converting the KF850z Loudspeaker to bi-amp capability
and can only be used on a KF850 that was originally manufactured as a KF850z. It cannot be used on a KF850
originally manufactured as a KF850E that was upgraded to a KF850z.
Warning: Installation should only be done by an
experienced technician. Improper installation may
result in damage to the equipment, injury or death.
KF850z Bi-Amp Crossover Retro Kit Parts List,
EAW P/N 0007951:
Item EAW P/N Qty Description
A 0007523 1 Bi-Amp Crossover
B 102087 5 Wood Screw #8 x 1 Lg PH
C 0007748 1 Sticker/AP6/Bi-Amp
D 0007749 1 Sticker/NL8/Bi-Amp
E 0007952 1 Instructions (this sheet)
OVERVIEW
KF850z Bi-Amp Crossover Kit installation requires the technician to:
1. Lay the enclosure down onto its front.
2. Remove the rear access panel.
3. Flip the panel over and rest it on the enclosure’s back.
4. Position the new crossover board on the inside of the access panel.
5. Screw the new crossover board to the access panel.
6. Unplug the existing wiring.
7. Connect the new crossover board.
8. Remove two existing wires.
9. Reattach the rear access panel.
10. Attach the appropriate sticker to the input label.
11. Return the enclosure onto its standing position.
INSTRUCTIONS
B
A
PIN 1--...NC
PIN 1+...NC
PIN 2--...LF--
PIN 2+...LF+
PIN 3--...MF/HF--
PIN 3+...MF/HF+
PIN 4--...NC
PIN 4+...NC
D
C
PIN 1...LF--
PIN 2...LF+
PIN 3...MF/HF--
PIN 4...MF/HF+
PIN 5...NC
PIN 6...NC
KF850z
Loudspeaker
1. Insure your work area
is clear of objects that can
damage the enclosure’s
steel grill then set
the enclosure onto
its front.
2. Remove the 10 hex head
bolts and washers that attach
the rear access panel. Do not
discard this hardware.

EAW KF850z Specifications

General

Brand	EAW
Model	KF850z
Category	Speakers
Language	English