Need help?Do you have a question about the EAW UXA Series and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Networking | Ethernet |
| Software | EAW Resolution |
| Input Impedance | 10k ohms |
| Cooling | Variable speed fan |
| Connectors | XLR |
Explains symbols like CAUTION, WARNING, and IMPORTANT NOTES for safe operation.
Covers guidelines for supports, trolleys, carts, and proper waste disposal.
Procedures for unpacking and suitable installation conditions for the amplifier.
Steps to securely install the amplifier in a rack cabinet.
Instructions for maintaining optimal thermal conditions and airflow for the amplifier.
How to connect the amplifier to the main power source using the PowerCon connector.
Details on Analog and AES/EBU digital input pin assignments and specifications.
Pinout and description for digital audio links (01/2 - 03/4).
Explains Direct Mode and Relay Bypass for signal integrity.
Specifications for SPEAKON connectors used for output signals.
How to connect multiple units in a daisy chain configuration for Dante networks.
Setup for implementing concurrent Primary and Secondary network connections.
Operating modes and functions for general purpose inputs (GPI).
Configuration for general purpose outputs (GPO) and fault status reporting.
Describes display, controls, and navigation methods for the HMI.
Explains the different sections of the HMI display for monitoring and control.
How to use bistable and toggle buttons on the interface for selections.
How to make selections from lists using the edit knob and short press.
Adjusting parameter values directly within buttons using the edit knob.
How to use selection buttons and popup windows for parameter setting.
Scrolling and selecting desired items from various lists.
Using alphanumeric and numeric keyboards for text and IP input.
Understanding the confirmation dialog for saving scenes to prevent data loss.
Configuring tone generation and digital link outputs for audio signals.
How tabs adapt to speaker category and model changes reset parameters.
Setting the number of speakers connected in parallel per channel.
Choosing specific presets for selected speaker models.
Setting custom names for output zones served by the speakers.
Defining input source selection and routing methods for audio signals.
Customizing device name and defining power-up behavior on connection.
Adjusting display brightness, touch calibration, and panel lock features.
Utilizing factory reset options for device parameters.
Monitoring amplifier temperature and protection status across channels.
Setting the UDP port for the OSC server for remote control.
Procedure for removing authorized clients from the OSC whitelist.
Information displayed during temporary malfunctions and suggested actions.
Initial steps to connect the computer and software to the amplifier network.
Methods to add devices to the network configuration view.
Creating an offline model of the amplifier for configuration.
Resolving issues with push/pull operations and firmware compatibility.
Choosing the input source for DSP processing.
Setting input sources, gain, and polarity for audio signals.
Configuration of pilot tone detection and audio level monitoring.
Understanding signal routing diagrams and meters for audio flow.
Steps for updating firmware and resolving common issues.
To Next Page
