3.
1.
2.
-32-
Lightly tighten 3 of the 5 blade screws (1.)
(with washers), remove the blade changing
tool (2.) and lightly tighten the remaining blade
screws (with washers) (3.).
Remove all tools and distribute paper along
the entire cutting length.
Turn main switch to position I. (1.) The blade
will return to the upper position and the blade
screws should be tightened firmly (2.).
Close the safety guard (1.) Lower the blade by
pressing both cutting buttons (2.). Keep one
button pressed and turn off the main switch (3.).
Open the safety guard (4.). With the special
wrench (B) the 3 eccentrics shall be screwed
so far down (5.)until the paper is cut along the
entire length of the blade (The blade must
remain parallel, not too deep into cutting stick).
To Next Page
Loading...