EBA 430 E - Page 40

EBA 430 E • EBA 430 EP
-41-
cm
inch
EBA
"Service"
C
B
A
D
-40-
Motor runs but blade does not move
downwards.
• Security brake has been activated!
Inform the service team!
www.EBA.de
➞➞
➞➞
➞ "Service"
service@krug-priester.com
Display illumination off
• Machine is plugged in? (A)
• Main switch on position "I"? (B)
• Key turned to the right ?(C)
• Push in the security button! (D)
• Check the fuse of the buildings’
• electrical installation!
EBA 430 E
Cut cannot be made.
• If cover is open:
close it.
• If cover is closed:
open and re-close it. (Security check).
EBA 430 EP
Cut cannot be made.
• Measurement has not been driven to
correctly.
• LED "S"
X
does not turn off.
Push again the
S button.
Security check of the cover (see above)
• Measurement below 9 cm
Hold the
S button
O
until the measure is
achieved.
• Backgauge
I
does not move, the display
shows "
C "
Turn the pressing lever
E
to the right.
• Backgauge
I
does not move to position
(pressing lever has been turned to the right).
"
C" is in the display
➞ inform service people.
All manuals and user guides at all-guides.com