UNDERSTAND YOUR TOOL
YQK series are the tools for connecting lugs and cable. It carries many advantages of good
design, easy operation, high pressure, high efficiency etc. They are the perfect tool to be
used in electric construction site.
1． Specification
16.25.35.50.70.95.120.150.
185.240 mm
2
10.16.25.35.50.70.95.120.1
50.185.240.300 mm
2
The dust or air inside the tool will damage the sealing kit so caused the
tool lose function. Make sure the oil is clear and no dust entering into
oil when changing oil. Wait for a while and exhaust the oil completely
out of the oil tube before inserting the oil plug.
Please wear the rubber gloves to avoid skin touching the oil directly, if touches it
in careless, please wash the skin by soap water in timely. In order to protect
the environment please drain the waste oil to the treatment center where was
approved by government.
TROUBLESHOOTING
A. No pressure or the
pressure is not enough
during operation
1. The pump lack oil
2. There is dust exist in oil
3. Inner leakage
1. Fulfill or replace the oil
2. Change the oil
3. Contact manufacturer or
distributor
B. The lug and wire do
not connect tightly
after crimping.
1. The tool can not reach
to the rated pressure
2. Use the wrong die
1. Refer to the fault A
2. Replace with the right
die
C. Generate a lot of
burs after crimping
1. Replace with the right die
D. Oil leakage on the
head or on the ram
1. Contact manufacturer or
distributor and replace it by
trained person
To Next Page
Loading...
Need help?
General
