9
6. Receive Mode
As soon as the device is switched on as
described under 5., it is already in receive
mode.
a) Setting the Volume
Press the buttons ▼ VOLUME ▲ to
adjust the volume.
b) Selecting the Reception Range (Band)
Select the desired reception range with
the sliding switch:
- USW = Ultra Short Wave
- MW = Medium Wave
- SW = Short Wave
- LW = Long Wave
c) Changing the Medium Wave Rage
The frequency range and tuning intervals of
MW vary by region:
Set the sliding switch to
- up in the region "USA"
- down in the region "Europe".
d) Searching for Stations
Press briefly on one of the two TUNING
buttons to search upward or downward
in steps.
Hold one of the TUNING buttons pres-
sed to start a scan. The device stops as
soon as a sufficiently strong station is
found. Pressing the button again will
continue the scan.
To Next Page
Loading...