Step 4 Make sure the machine is empty and ready to be run at maximum speed.
Select “Yes” and press the Enter Button.
Step 5 Machine will now run at maximum speed for one minute. You will see
the tachometer scaling ratio displayed on top and the DAC (Digital to Analog
Converter) set point displayed on the bottom. The RPM (####) is your target
speed. The RPM on the right side is the tachometer reading. You will need to
monitor this value and compare it with your “Calibration Test Kit.” The
“Calibration Test Kit” will show the TRUE RPM reading of the machine.
To Next Page
Loading...