LUBRICATION:
See exploded view of shaker power unit for points of lubrication. Use a good
grade of SAE #30 oil.
Lubrication when shaker is used in continuous duty applications of 100 hours or
more:
A. Oil crank bearing through hole in center of bearing bracket every 3 months.
B. Oil the 8 bearings located at the top and bottom of each of the 4 rocker arms
every 3 months. Place oil on the shaft next to the bearing.
C. Oil the connecting rod bearings every 3 months. Place oil on the shaft next to
the bearing at the upper end and at the crank end of the connecting rod.
Lubrication when shaker is used for intermittent duty:
A. Oil crank bearing through hole in center of bearing bracket every 6 months.
B. Oil the 8 bearings located at the top and bottom of each of the 4 rocker arms
every 6 months. Place oil on the shaft next to the bearing.
C. Oil the connecting rod bearings every 6 months. Place oil on the shaft next to
the bearing at the upper end and at the crank end of the connecting rod.
To Next Page
Loading...